"G94"

[ahaslam]

I am looking to use a G94 at the end of my tapping cycle after all the holes have been tapped.

 

ptap$        # Canned Tap Cycle
  n$,"G93",e$
  n$, *sgdrill, g98_g99, *x$, *y$, *dpoint, *refht$, pplunge,e$

 

if I put it in as a new line in will run after the first hole has been tapped canceling my IPR before all holes have been tapped. so I have been sticking it in my g80 line.

 

pcanceldc$   # Cancel canned drill cycle
           n$, "G80", "G94",e$

 

I just don't like that it pops up every time I use g80.

 

How can I get it to cancel after all the holes have been tapped?

 

 

 

[Ben Wood]

There may be better ways but here is how I did it in my post. 

 

 

Near the beginning of the post were the variables are initialized I created a new one.  You can name the variable something else if it makes more sense to you.

 

test1          : 0

 

 

At the beginning of the pretract post block I added

 

if test1 = 1, "G94", test1 = 0, e$

 

 

In the ptap post block I added

 

test1 = 1

[MIL-TFP-41]

something like this....

 

n$, "G80", e$

if drillcyc$ = 3, n$, "G94", e$

[ahaslam]

something like this....

 

n$, "G80", e$

if drillcyc$ = 3, n$, "G94", e$

 

Thanks MIL, This gave me just the ticket.

[ahaslam]

Maybe you can peg my next one.

 

pplunge        #
              if frplunge$ > 0, *frplunge$

 

ptap$        # Canned Tap Cycle
  n$,"G93",e$
           n$, *sgdrill, g98_g99, *x$, *y$, *dpoint, *refht$, pplunge,e$

 

I want to output IPR in my pplunge.