BUG

[Pizza_m79]

Hi

 

I bug I found the other day. I will try to explain my best and added a picture as well. 

What you see is a simple program with parts placed on a single plywood sheet and the smaller parts are

connected with a few tabs. Nothing extra and when it was made the first time it worked as i should.

 

Today I went in and replaced the geometry in the middle (red arrow) with another shape and chained it

as I usually do. Here comes the bug, it added the new one but at the same time some of

the existing toolpaths disappeared. As you see, same number of chains still exists but the upper right

piece (blue arrow) have taken the missing four geometries so it spins FIVE times around same piece.

 

Also all tabs are now missing and I belive it has something to do with the tab option. This has occured

sseveral times for me but ONLY when I go into an existing operation and add or replace chains.

 

MASTERCAM X9

 

ideas? 

[Guest]

Did you actually regen it? Or are you just looking at the geometry chains?

[Pizza_m79]

It's 100% regenerated and as I mentioned its not the first time it happened. I sent same program to a colleague and he could confirmed it. The missing toolpaths had been transformed to the upper right geometry. Backplotting, verifying and final program all the same.

[Guest]

Well, I would suggest you send it into to QC and see if they can reproduce it....

[Pizza_m79]

New test. Tried to make it happen again and this came out. 

 

TEST1 shows circles and boxes with some tabs, all ok. 

TEST2 added two triangulars + tabs, still ok. 

TEST3 added those triangulars again but first in chainlist (nr 7 and 8), before the previous chains 

 

and this happened TEST4 It left most of the tabs away and rearranged the few that remained.

This did NOT happen if the new chains was added last on the list and then moved ontop of the rest.

 

Matias...