Post Processor

[linebore]

Can anyone help me locate a Mastercam V6 post processor written for a Siemens 810T 2-axis Lathe control. Any help would be greatly appreciated.

[Allan Brown]

Sent you an email with a few posts I was able to dig up. No promises on the suitability of the posts.

[omar8589]

On 04/04/2000 at 09:08, Allan Brown said:

Je vous ai envoyé un e-mail avec quelques messages que j'ai pu déterrer. Aucune promesse sur la pertinence des postes.

I am looking for the mastercam post processor for sinumerik 820T or sinumerik 810T.
if you can help me, i would be very grateful.
thank you.

[gcode]

Your Mastercam dealer is the place to go with this request

[gcode]

I just noticed that this thread is one of the oldest on eMC

[gcode]

And this has to be one of the very first