Need some help with an old Fanuc

[bigprody]

We have an Old Okuma Howa with a 15-M control. It has erred on a few tool changes over the years and we have a few pockets that now are referenced as tool zero. Where can I set the parameters to get this thing straightened out?

[Newbeeee™]

I think toolchangers are usually controlled within the Keep relays and PLC side of things.

[Guest]

Is it a 15i?

 

Different builders do different things. Some use Data bits, others have that information hidden, others have a separate tool table that is accessible through custom screens.

 

As of today AFAIK, it operates as a subsidiary of Okuma Corporation and has no other means of contact (unless you call Japan directly). I would suggest getting in touch with Okuma in the US (not one of their dealers) and approach it that way.

 

Best of luck.

[bigprody]

Thanks guys, as usual the core group here is always wiling to share and help someone who is stuck. I will try and give the Okuma mother-ship a jingle.