plunge settings in lathe

[jlw™]

is there a way to make this default?

[Guest]

OP defaults

[Colin Gilchrist]

Have you edited the Operation Default files before? Go take the Defaults file, rename the file extension to ".mcam", and open the file inside Mastercam. Edit the Operation Parameters for each Op to make them as you want them, then save the Mastercam file. Then rename the file extension back to the original. (Always make a backup copy before you start messing around!)

[jlw™]

I have note.  It's been so long since I did that I had forgotten it.

 

Thanks gentlemen.