Wire skim cuts only

[Rocketmachinist]

How do I do a wire pass that skips the rough and 2 skims and goes strait to skim pass 3?

When I am on the cut parameters page the only way I get it to work is I have to click on perform rough cut and then do the 2 skim passes. But, I don't want the rough.

 

Never mind I figured it out. I just didn't understand that even though I told it to start on skim pass 3, the rough cut isn't using the burn codes of the rough but the burn codes of the skim. I was expecting it to say skim for that pass and not rough.

Edited March 28, 2017 by Rocketmachinist
figured it out