End Mills for 304SS?

[#Rekd™]

Hi,

Looking for some suggestions for some high performance end mills for cutting 304SS. The ones we use are usually between 1/8" to 3/8" diameter. I want something for slotting, pocketing, contour ramps ect.

Thanks in advance.

 

[Guest]

Helical Solutions

Hanita

Destiny

Just for 3

Edited March 30, 2017 by Guest

[jeff]

Guhring RF 100 VA are made specifically for Stainless.

http://www.guhring.com/ProductsServices/Tools/?Type=39

I've also had great success with the Hanita Varimills in S.S.

[Matthew Hajicek - Singularity]

I'm having good results with Helical in 17-4 H900.

[BrianP.]

Always had great luck with the variable helix mills. MA Ford Tuff-cut series, Garr VRX series and SGS Zcarb series. Used to do a job one place 17-4PH with flame cut edges. Was absolutely amazed at how well the MA Fords held up. There would be chunks missing from the flutes of a 1/2 inch endmill and it would still be cutting.

[Solidworkscadman]

Guhring Endmills with the firex coating is the best results I have had,

the endmills have a small break edge on the corner to hold up

[Orvie]

I use the Guhring RF 100 Speed end mills with much success.

They are made specifically for Dynamic Style tool paths.

The core is very thick for rigid cuts & the web is thinned for ramping and plunging.

https://www.dropbox.com/sh/smr3vo9js7u9a3x/AACA7vVrqZNCACCAvIa3auONa?dl=0

RF 100 Speed_USA_8-2.pdf

GUHRING RF100 SPEED ENDMILLS STAINLESS STEEL OVER 233HB.tooldb

GUHRING RF100 SPEED ENDMILLS STAINLESS STEEL UNDER 233HB.tooldb