Dynamic xform to compound axes feature

[protoman]

We are on x9. Just recently started playing with dynamic xform. Is there a way to xform a certain feature of a part to origin while telling it to face up in z zero in the same manipulation? Example being a counterbore on top of a thru hole at a compound angle of axes relative to a face surface. More simply, can I xform an entire part at odd angles in 2 separate axes based on one particular feature and tell it to put that feature perpendicular to z?

thanks 

[3R!< W3NG3R]

Short answer, yes. 

There is a button to change from gnomon manipulation to geom manipulation.

You need to toggle back and forth as necessary. It's hard to explain without seeing what you want to do and not showing you. This is one of my favorite functions in MC

[protoman]

I'll check it out tomorrow. What's the toggle button logo look like? And what does it say when hovering over it? I looked around but nothing seemed like what I was looking for. Then again I might have over looked it. I'll look at it again tomorrow. 

[David Colin]

You can switch with control key or you can use context button near gnome (bottom left) in graphic area