Jump to content

Welcome to eMastercam

Register now to participate in the forums, access the download area, buy Mastercam training materials, post processors and more. This message will be removed once you have signed in.

Use your display name or email address to sign in:

Scallop avoidance surface


DavidB
 Share

Recommended Posts

49 minutes ago, gcode said:

In 2018 high speed scallop, you can have multiple sets of drive surfaces

Each set can have a different stock allowance

You can use this feature to fake a check surface in some cases

I tried that, but it was not cutting up to some edges I needed by doing that. By using the old school and check surfaces I was done.Thing I miss old school verse the new HST is with boundary and contact point verse tip control. That does a nice job when you can use it on HST toolpaths. What are we 6-8 years into HST toolpaths for finishing and we are about 50% there to match what old school ones did. At this rate by the 2025 Release they will be able to match what the 1998 release was doing.   :whistle::sofa:

  • Like 2
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.

Join us!

eMastercam - your online source for all things Mastercam.

Together, we are the strongest Mastercam community on the web with over 56,000 members, and our online store offers a wide selection of training materials for all applications and skill levels.

Follow us

×
×
  • Create New...