G154 P.....

[motor-vater]

So I'm playing with the MPMaster 2018 and I want to get haas offsets. I am no post expert but seems straight forward enough to figure out with your help.

Right now its set up to output G54-G55-ETC until it gets to the P's but the post is outputting G54.1's instead of G154's Looks like somehow I must tell the post this is a haas. Is that something in the machine def, or control def? I'm preety sure the IF/Else Comments are trying to do what I want allready?

pwcs            #G54+ coordinate setting at toolchange
      if wcstype = two | wcstype > three,
        [
        sav_frc_wcs = force_wcs
        if sub_level$ > zero, force_wcs = zero
        if sav_mi9 = 1, workofs$ = sav_workofs
        if workofs$ < 0, workofs$ = 0
        if workofs$ <> prv_workofs$ | (force_wcs & toolchng) | sof,
          [
          if workofs$ < 6,
            [
            g_wcs = workofs$ + 54
            *g_wcs
            ]
          else,
            [
            if haas,
              [
              p_wcs = workofs$ - five        #G154 P1 to P99
              "G154", *p_wcs
              #g_wcs = workofs$ + 104        #G110 to G129
              #*g_wcs  
              ]
            else,
              [
              p_wcs = workofs$ - five
              "G54.1", *p_wcs
              ]
            ]
          ]
        force_wcs = sav_frc_wcs
        !workofs$
        ]

[Guess_who]

You'll have to look and see how it's configured in the post. Seach for the variable haas

[Guess_who]

Just change the '0' to a '1' on this line

 

haas        : 0     #Haas style peck drill and extended offsets, 0=no, 1=yes

 

 

[motor-vater]

Guess who you r the man! That did it perfectly