Vericut drill cycles with Fagor controll

[RaiderX]

I know there are a few very smart Vericut users on this forum so looking for a little help setting up with our Fagor control drill cycles.

the freak part of this machine is G83 Z.1 I.1 J5 peck drills a hole .500 deep from the Z value. this is the format per the book and how our machine inturpets it. 

my problem is as I understand it vericut has macro's that you assign to the address. ie Z would be assigned to initial start point macro. am not sure what macro's to assign to i and j and or how to make it calculate j X i = final depth from z

I do not need to simulate the peck movement but would be nice.

thanks in advance if someone can point me is a correct direction

Doug

 

[RaiderX]

I fingered it out.

funny thing vericut support said they could not do it. lol

[Nuno Ribeiro]

I have started working with the mastercam x5 i also worrk with the machine Mill with fagor 8055 fagor command can some one help me with the post processors for

this machines?

[#Rekd™]

1 hour ago, Nuno Ribeiro said:

I have started working with the mastercam x5 i also worrk with the machine Mill with fagor 8055 fagor command can some one help me with the post processors for

this machines?

Yes your reseller, asking for someone to "give" you a post is forbidden here.