tool inspection

[Rocketmachinist]

I have a small problem with the tool inspection cycle. After the M00 the machine changes itself to G96 to G97 and doesn't turn the coolant back on. How do I fix this?

 

ptool_insp      #Tool inspection point
      #Modify following lines to customize output for tool inspection points
      if posttype$ = two, #Lathe tool inspection point
        [
        "(TOOL INSPECTION POINT - POST CUSTOMIZATION MAY BE REQUIRED)", e$
        if prmcode$ = 29999, #Only output tool insp comment if one was entered with this insp point
          [
          sparameter$ = ucase(sparameter$)
          pbld, n$, *sm00, sopen_prn, sparameter$, sclose_prn, e$
          ]
        else, pbld, n$, *sm00, e$      #Output just the stop if no comment
        pbld, n$, *sgcode, *toolno, e$ #Restate tool number
        pbld, n$, pfsgplane, e$        #Restate plane code
        prpm # Output programmed RPM   #Restate spindle
        prv_feed = c9k                 #Set prv_values to c9k to force them out with next moves
        prv_gcode$ = c9k
        prv_workofs$ = c9k
        if coolant$, prv_coolant$ = c9k
        ]
      else, #Mill tool inspection point
        pbld, n$, *sm00, "(TOOL INSPECTION POINT - POST CUSTOMIZATION REQUIRED)", e$

[Rocketmachinist]

So this is what I need to put in to fix this.

(TOOL INSPECTION POINT - POST CUSTOMIZATION MAY BE REQUIRED)
M00
G00 T0202
G97 S774 M3
G96 S200 M08 <---------------------------------------------(This line)
G00 G54 Z-.3175

[Werktuigbouwer]

To generate G96 line of code change

prpm to pcss