Back to 2018

[pip]

Just started back in Mastercam from a 3 year break. using 2018 where is the command to draw a circle or an arc, tangent to 1 line, and through a point.

I gave up looking this evenning..

[neurosis]

9 minutes ago, pip said:

Just started back in Mastercam from a 3 year break. using 2018 where is the command to draw a circle or an arc, tangent to 1 line, and through a point.

I gave up looking this evenning..

I never used 2018 - this is 2019 so hopefully its in the same place if this is what you're looking for.

Go to <wireframe> in the ribbon.  In the arcs menu, look for <arc tangent> .  There is a drop down menu.  Arc one point.  

[gcode]

On the Home page there is an icon Labeled "Command Finder"

It can help you find X9 commands in MC2018

[Mark VIII]

On the "Wireframe" tab select the "arc tangent" icon and your options pop up.