Okuma MB56VA OSP-300 Rotary Axis Parameter SetUp

[Carlos Sandoval]

Hi to all,

I am Carlos Sandoval

I'm starting to program in 5 axes in mastercam everything looks great but when I go to the machine I have an alarm. When I check my machine I notice that the rotary axis parameter page does not exist  any setting. Does anyone know how to do that setup?  

I will appreciate any help.

[Greg Williams]

Sounds like it is turned off, extend the screen then there should be a display all button there somewhere

[jeff]

On 11/3/2018 at 9:09 AM, Carlos Sandoval said:

Hi to all,

I am Carlos Sandoval

I'm starting to program in 5 axes in mastercam everything looks great but when I go to the machine I have an alarm. When I check my machine I notice that the rotary axis parameter page does not exist  any setting. Does anyone know how to do that setup?  

I will appreciate any help.

What alarm are you getting?

Is your machine actually set up for 4 and 5 axis? That's typically a $5k option from your Okuma distributor.