Haas UMC750 thru spindle air

[MetalSlinger5]

need help getting post to spit out M73 (on) M74 (off) for thru spindle air?

[crazy^millman]

Look at your machine definition and make the changes there. 

[DRIPPY]

Hi Metal Slinger

This is an extract from my UMC post. You need to add your M73 and M74 here before you can do anything.

This will output through tool air by using the Coolant 4 seletion in your coolant selection dropdowns inside you operation parameter page.

 

# --------------------------------------------------------------------------
# Coolant output code selection for X style coolant
# Note: To enable X style coolant, click on the General Machine Parameters icon
#   in the Machine Definition Manager, Coolant tab, disable first check box
#   Output of X style coolant commands in this post is controlled by pcan, pcan1, & pcan2
scool50 : "M8"                 #Coolant 1 on value
scool51 : "M9"                 #Coolant 1 off value
scool52 : "M83"                 #Coolant 2 on value
scool53 : "M84"                 #Coolant 2 off value
scool54 : "M88"                #Coolant 3 on value
scool55 : "M89"                #Coolant 3 off value
scool56 : "M73"            #Coolant 4 on value
scool57 : "M74"           #Coolant 4 off value
scool58 : "M8(Coolant5=ON)"    #Coolant 5 on value
scool59 : "M9(Coolant5=OFF)"   #Coolant 5 off value
scool60 : "M8(Coolant6=ON)"    #Coolant 6 on value
scool61 : "M9(Coolant6=OFF)"   #Coolant 6 off value