optomec cs800

[cherokeechief79]

we just got this new laser deposition additive mfg machine in.

I'm going to be tasked with programming or training others because of my 5 axis haas umc 750  knowledge.

this machine has a trunion table and I'm told mastercam has a post and a full simulation for this specific machine.

any of you guys using one of these or something similar.

I will have a lot of questions.

thanks as always!

 

[Chris In-House Solutions]

Hey Mark,

What kind of Machine is it?  I dont believe Mastercam has a post and the software is currently setup to typically remove material not add it.  I do believe they are working on building an addon to add material but am not sure where its at or when you might be able to go your hands on it.  At this point your best bet would be to reach to your reseller and inquire about getting a custom post processor.   

[AlbertZini]

http://camufacturing.com/aplus.cshtml