Sign in to follow this  
SlaveCam

Cimco DNC transfer tab lost

Recommended Posts

So we bought Cimco professional a while back and I'm quite sure there was a file transfer tab there in the user interface. It was updated to 8.02 at some point and now the file transfer tab has gone missing. Do I have to purchase it separately too? All I want is CImco as it comes with Mastercam but installed on a non-Mastercam PC. I don't need simulation etc., only file transfer.

Share this post


Link to post
Share on other sites

SlaveCam

 

In the global setup of Cimco make sure the  "Disable DNC/Serial communication" is not selected

 

image.thumb.png.e5c1e220c7002b00027d205edb3b7e14.png

Share this post


Link to post
Share on other sites

It is grayed out and unchecked. CimcoDNC.exe however exists under installation directory. The tab is just missing.

 

Share this post


Link to post
Share on other sites

Check your Cimco shortcut, your likely using Cimco basic attached to Mastercam Sim.

If opening .nc file directly check windows default association (prolly looking at MCX cimco)

If launching direct from Mastercam check your Start tab and make sure "CIMCOedit" is selected not "CIMCO"

image.png.498fefb890470c6f4da80ccde6754c7b.png

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

Join us!

eMastercam - your online source for all things Mastercam.

Together, we are the strongest Mastercam community on the web with over 56,000 members, and our online store offers a wide selection of training materials for all applications and skill levels.

Follow us