Setup Sheet is Taking too much time to open up

[Kenny Machado]

Hello everyone,

 

I tried recently to start using Setup Sheet processes in Mastercam (2018 or 2019), and it is taking around 72 seconds to open.

 

I am using the SS default from Mastercam (mill, lathe, wire, etc).

 

Does anyone know if there's a process that I can do to test and verify what's going on?

This will help me a lot!

 

Thanks to all!!!

[The Chipmaker]

  I am experiencing too!  I have been using set up sheets as long as 2019 has been installed. The last month something changed and it does take over a minute to open. Can't help you , but you aren't alone.

[So not a Guru]

This is why I use X+ setup sheets. The more complex your MC file is, the longer Active reports takes to generate sheets. A few years ago, before I knew about X+, I had some files that would take up to an hour to generate a sheet!

Günther rocks!!