ISO MATERIAL GROUP

[PcRobotic]

Hello everyone,
    For the last 3 versions, MasterCam didn't include the parameter for the ISO MATERIAL GROUP (I am guessing) and I am trying to call out some MATERIAL ISO GROUP but failed.  Probably I did in a wrong way, I hope 2020 version they improve it.   

   I always wanted to use this "ISO GROUP" to show a message if SST then do "A" if aluminum then do "B", etc....

PS: Below here is how I defined and surely I think I did something wrong, can you guys point out what I've done wrong?  

 

Thank you.....

 

====================================

fmt "Unknown" 4 sUnknown
fmt "P - General Steel" 4 sGeneralSteel
fmt "M - StainlessAndCastSteel" 4 sStainlessAndCastSteel
fmt "K - Cast Iron" 4 sCastIron
fmt "N - Aluminum Copper And Non-Metallic" 4 sAluminumCopperAndNonMetallic
fmt "S - HighTemperatureSupperAlloys" 4 sHighTemperatureSupperAlloys
fmt "H - HardenedSteelAndIastIron" 4 sHardenedSteelAndIastIron

 

 

    if prmcode$ = 19123,
       [
        sUnknown = rpar(sparameter$, 0)
        sGeneralSteel = rpar(sparameter$, 1)
        sStainlessAndCastSteel = rpar(sparameter$, 2)
        sCastIron = rpar(sparameter$, 3)
        sAluminumCopperAndNonMetallic = rpar(sparameter$, 4)
        sHighTemperatureSupperAlloys = rpar(sparameter$, 5)
        sHardenedSteelAndIastIron = rpar(sparameter$, 6)
       ]

 

 

 

ISO_Group: 0
sUnknown : 0
sGeneralSteel: 0
sStainlessAndCastSteel: 0
sCastIron: 0
sAluminumCopperAndNonMetallic: 0
sHighTemperatureSupperAlloys: 0
sHardenedSteelAndIastIron: 0