Dynamic mill and pocket not leaving stock on a Wall.

[Tinger]

Hello all,

I need an experts help .

Both a dynamic mill, and pocket operation in my mcam file are not leaving stock on a wall surface and I can't figure out what I'm doing wrong.

I have attached the file. the operations in question are # 6 & 9. Also, I had to use a containment, air, and machining region for it to recognize the area properly. I would have just used a machining region and an avoidance region, but it wouldn't recognize properly.

Any help is appreciated.

C7956902.ZIP

[ajmer]

take a look at this simplified file

i used multi machining regions 

set it to stay inside

and multi air regionsajmer_ihs_C7956902.mcam

 

[Tinger]

1 hour ago, ajmer said:

take a look at this simplified file

i used multi machining regions 

set it to stay inside

and multi air regionsajmer_ihs_C7956902.mcam

 

Thank you! I appreciate the help. I never considered having an open chain for an air region.