matsura mx-520 pc4

[Leon82]

Can I ask how strong is the flow of  your pallet clamp wash in your pc4?

[mike93]

B

On 2/11/2020 at 6:48 AM, Leon82 said:

Can I ask how strong is the flow of  your pallet clamp wash in your pc4?

The coolant is about 1" but 2 are better then the other 2

Braking news, BROKE the window, "Loose" part cased a broken insert in a mits cutter to fly out at 10000 RPM!! We are still getting at least 22-5 a week up time switching parts next week so we will be back to 24-5.5, it likes to run, In my Pure innocent mind the glass goes to low, looking at a few other machines the glass stops about 6-8" above of the table?

[Leon82]

28 minutes ago, mike93 said:

B

The coolant is about 1" but 2 are better then the other 2

Braking news, BROKE the window, "Loose" part cased a broken insert in a mits cutter to fly out at 10000 RPM!! We are still getting at least 22-5 a week up time switching parts next week so we will be back to 24-5.5, it likes to run, In my Pure innocent mind the glass goes to low, looking at a few other machines the glass stops about 6-8" above of the table?

Same on ours. They switch manufacturers it's not a tsudakoma trunnion anymore.ours was actually making a clunking noise as it clamped

[?Mark]

On 1/30/2020 at 5:58 PM, mike93 said:

we have not tried camplete yet, we do have it on the flash drive,  but have not installed it yet, but the post and simulator in master cam are working fantastic, we can take programs from are  mazak 500 change the post and switch mis integers  and it runs in the matsuura, that is switching from BC to AC axis! every thing is looking up just proved out another part today (it takes time to build all the holders) but we are doing it right this time, build all holders before they go into machine, we bought  over 100 to get started but some are the same so it should not take to long.

Listen to James and try Complete, especially since you already have it and paid for it.