Leaderboard
Popular Content
Showing content with the highest reputation on 02/04/2020 in all areas
-
In other words, you're boss is not willing to pay to train you This forum is great for knowledge but it can't train you....3 points
-
We only use Karnasch tools for copper for our electrodes. We order out of Germany for them and get as small at .2mm ball nose tools that are typically 0/-.01mm2 points
-
I'm a pretty big fan of Union Tool for this (copper electrodes), they have different tolerance levels you can buy but I think the worst is +/- .01mm which is just shy of .0004"1 point
-
Verify has the option. It's in the verify tab in the Analyze toolbar. Not sure about the stock model though.1 point
-
Select output options to get to the filtering page, also you have tolerance and toolpath corner % to play with.
1 point -
Mic 6 is a cast aluminum material so a cut thread will have less holding pressure than with wrought/ extruded material. Depending on the thread usage you may want to roll tap to get the increased holding pressure.1 point
