Leaderboard
Popular Content
Showing content with the highest reputation on 07/28/2021 in all areas
-
I am starting a small business at home with a CNC router, I am cutting carbon fiber and G10 sheets the carbon fiber will most of the time be 3mm thick, what would e a good speed and feed for this to help my tooling last longer. I'll most likely be using a 1/8" endmill the most.1 point
-
Ok, ill get a fresh start tomorrow and try to rename in this manner. Ill update the thread if I'm successful. Thank you1 point
-
We used the Harvey diamond coated with the double helix. It pulls up on bottom and pushes down on top. We cut a bunch of windows with it. It tends to splinter if not supported so make a nice cap to hold it down1 point
-
Maybe try the NX forum?1 point
-
I've never cut it myself, but a late friend of mine did a lot of it and he said he used the oscillate option whenever possible to increase tool life.1 point
-
It is, so fast I`m wondering if I did something wrong I`ll run it again tomorrow1 point
-
MERHABALAR BENDE DAHA GELİŞMİŞ VERSİYONU VAR İSTEYEN OLUR İSE MAİL ATABİLİRİM
0 points
