Register now to participate in the forums, access the download area, buy Mastercam training materials, post processors and more. This message will be removed once you have signed in.
Use your display name or email address to sign in:
Hello all, i have DNC-T of machine v4020 , i connect DNC-T vs machine ok, but i have problem in mode Auto ,it has not device TC into get program to TC of DNC-T to run,when i auto mode - iso TC: TEST.MIN -write , alarm 300 device appear, i think device TC have to set parameter, but i don’t know set parameter any , every one have help me , please!!!
I WAS PROGRAM INPUT, BUT WITH THE PROGRAM MORE THAN 1M IT DEVICE FULL ERROR,I EDIT 1PROGRAM A.SDF
A
A
A.SDF
PSELECT TC:\FACE.MIN
END
I PRESS CYCLESTART , ALARM B 2203 Schedule program load 10020000
you can help me ,plesea!!!!!!
HELLO ALL
I CONNECT DNC-T
EDIT---DNC-T----PROGRAM INPUT---FILE N2.NC, BUT MACHINE ALARM 5003 DNC-T ERROR 3
I CHECK FILE N2.NC
$N2.MIN%
-
-- CODE
-
-
M30
%
BUT IT STILL ALARM
PLEASEEEEEE!!!!!!!!!!!!!!!!
HELP!!!!!!!!!!
hello Rick Lees, I have connected to DNC-T through device TC , but I have the problem that I cannot get program in the path to TC to the main progam to run, help me with please!!!
hello Rick Lees, I have connected to DNC-T through device TC , but I have the problem that I cannot get program in the path to TC to the main progam ststo run, help me with please!!!
HELLO ALL! i want to connect DNC-T OKUMA OSP U10L, THE MACHINE have DNC-T but i don't connect to it, you can help me please!!!
or you can send me pdf of OSP-7000/700
OSP-U100/U10
OSP-E100/E10
DNC-T/DT/RT and IT Plaza Set
SUPPLEMENTARY MANUAL (SETUP PROCEDURES)
(2nd Edition)
Pub No. 5051-E-R1 (SE42-127-R2) Feb. 2005 please !!!!!
help me!!!
eMastercam - your online source for all things Mastercam.
Together, we are the strongest Mastercam community on the web with over 56,000 members, and our online store offers a wide selection of training materials for all applications and skill levels.