utsav
-
Posts
7 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Posts posted by utsav
-
-
I am getting an error that says the cutter diameter is larger than the arc diameter while using circle mill. I am trying to mill out a hole of diameter 0.55 inch with 0.5 inch flat end mill. I don't understand this error as this dose not make sense because my arc diameter is larger than my mill diameter. I also tried using a smaller mill 0.375 inch and I am still getting the same error.
Is there any way to mitigate the problem?
Thank You.
-
Using bounding box under the wireframe tabs and using the stock model under tool paths tab. When I did facing operation on the top of the stock and tried to simulate it, it did say that the volume of the stock was less for the simulation. I kinda figure the software added few more materials to compensate.
-
Hello MasterCam Community,
When ever I try to simulate all my operations, the stock shown on the simulation is bigger than what I originally specified. Is this normal? Is there any way to show my actual stock?
Thank You
-
Yep that works thankyou.
- 1
-
I just did that and It did not work.
-
Hello MasterCAM community,
I am relatively new in Mastercam and I have just been playing with the software with the help of some online tutorials. I cant seem to get a highlight on the part or edges or surfaces when selected so I am having a hard time knowing what I have actually selected. I tried going into configurations and checked 'Use Glow highlighting' but it didn't work. I also tried Clear all option under Model Prep < Color but that also dose not seem to work.
Please let me know if there is a solution to this problem on Mastercam 2022.
Thank you
How to get a good surface finish using 3D finishing tool path?
in Educational Forum
Posted
I am trying to put a finishing tool path on an angled slope using Raster but I can't seem to get a good surface finish. I am using the minimum stepover and letting the software automatically choose the scallop height. Can someone tell me what else I can try to get a good surface finish?