John@WMM
-
Posts
110 -
Joined
-
Last visited
John@WMM's Achievements
-
I have 1 library I use most of the time. I copy the tools and label them with different materials. Each tool then has a good starting point for SFM and IMP according to the material.
-
If you work on the shop floor its best to have a high desk with a tall chair. I go back and forth between the computer and machines and also sit down when programming gets really involved. We custom built all of our desk...
-
Depending on the depth i use: Helix bore to rough Circle mill with wear to finish I've had my fair share of scrap using the lead in/out options on a contour
-
Thanks for the help!!
-
Could use some help getting this part programmed. The slot is where I need help. SLOT.mcam
-
Thanks Pete! In the past the registration would happen automatically. Here lately I have had to manually register after every install/update. We have 17 seats so its not that fun...
-
Can you get that update to register the swdocumentmgr.dll during the install?
-
I had issues also... Our reseller updated our files and all is good now.
-
Its been fun going around and registering that swdocumentmgr.dll 16 times... then 16 times after the mastercam2019-update2-patch... not impressed
-
My 2018 is set in the config to open from desktop ... but over time it locks to a different folder... who knows why...
-
We built our own to use with tall chairs.
-
Extrending the start / end of contour, Wire EDM
John@WMM replied to Scott Lent's topic in Industrial Forum
On the "leads" you can set may lead in lead out options. On a hole diameter I use "line and arc/arc and line" with a radius value. On a straight line on and off I usually extend the lines, it makes it much easier to chain also... -
Thanks for the reply Jay. I didn't think it was possible...
-
Jay, Is it possible to lock in a position doing it the new way? With the XYZ boxs you could lock a value in... Is locking possible now?
