dolphin1
-
Posts
304 -
Joined
-
Last visited
Recent Profile Visitors
1,156 profile views
dolphin1's Achievements
-
Thank you
-
Trying to figure out how to add select chain in the right click menu. Thanks
-
Wanted to add another one to this, trying to add select a chain in my right click menu. Thanks
-
is your reference for inspection or programming
-
Thank you very much, didn't think about that one.
-
I'm trying to add to my right click menu and it seems the analyze position is gone from the things to add to the menu. any ideas. Thanks
-
my only comment is that it didn't do this in earlier versions. I get what your saying but its still still using the same lines. well ok.
-
ok so on op2 on finish top contour 2d i have the retract set to 0.0 and incremental but when you run it it keeps going back to the top starting position instead of just a .050 retract. 1281052.mcam
-
why is it that some times the 2d toolpath the incremental retract doesn't work right. it keeps going back to the first height on every retract.
-
so is the depth of the hole to bottom of hole or body diameter for drilling. if its to depth then the drill tip is .012 for a .055 drill with 135deg and you can run a form tap within .010 to .015 of the body depth. shouldn't be a problem. at .175 tapping depth you should end up with a thread depth of .135-.140
-
Thank you
-
never had this problem until today but I cant figure out how to change the license level I'm using. 2022 Thanks
-
wanted to thank the both of you guys for the help. it worked real good and I learned a few things I didn't know.
-
thank you very much yep that works. how do you get the red area to show on the middle image.
-
trying to do a dynamic contour on 3 sides of a part. left to right and there is a shape contour between. cant get it to work with a partial path for the avoidance. the description says it will do open contours so how do you tell it to do it. this is with 2022 OST1277375-2.mcam
