Register now to participate in the forums, access the download area, buy Mastercam training materials, post processors and more. This message will be removed once you have signed in.
Use your display name or email address to sign in:
Thank you Jack
That was easy. I should have seen that. It must have always defaulted to 10000 in other versions. cause I tant never touched it before.
thanks
Jody
When I verify I have true solids and turbo on then I will click on the fast forward button. In X2 the fast forward button doesnot always fast forward it will show the material disappering like the play button does. If I switch to the non turbo mode then fast forward works fine but is obviously alot slower.
I'm I the only one that has this problem?
thank you
Jody
In X Mr2 backup did not backup the autosave file ([email protected]) it would only backup the file that I am working on (job number123@100). Now in X2 It is still backing up the working file, but now also the autosave file and it does not limit the number of backups of the autosave to the 10 that is in the config. So I just deleted 71 files named [email protected] thru [email protected] in the directory that I am working on. Is that right? My dealer said that is what his does also. I like the X MR2 backup better.
Thank you
Jody
Mike
Could you put it up on FTP? Thank you
Gilberto,
My computer is very slow if I am generating a path then open another seat of Mastercam. When I turn on affinity from 0 to 4, 5, 6 and 7 on the mastercam that is generating a path the computer speeds up. I wish that I knew more about affinity and how to us it better.
thank you
Jody
Colin thank you
I have 8 processors it says because of hyperthreading. which numbers are the hyperthreading processors? and why are they not all on I think that would make every program running use all the processors avalible.
Where is the best drivers for the ATI firegl v3400 for Mastercam?
Thanks
Jody
What is 'Set Affinity' I am now running a dell somethin with two dual processors and hyperthreading. and a an ATI firegl v3400.
Mastercam does not seem any faster than the old 3.0 single processor to me. when I run cimco HSM and turn all 8 affinity's on then the time of process is almost the same as elapsed time. If I leave the affinity on just 0 is it using all the processors?
Thanks
Jody
New Place of Employeement
Regal Mold.
X Mr2 and Cimco HSM
eMastercam - your online source for all things Mastercam.
Together, we are the strongest Mastercam community on the web with over 56,000 members, and our online store offers a wide selection of training materials for all applications and skill levels.