Register now to participate in the forums, access the download area, buy Mastercam training materials, post processors and more. This message will be removed once you have signed in.
Use your display name or email address to sign in:
I have custom RMB and my ribbon toolbar(s)
Quite a few didn't migrate over.
They are not even visible in my custom toolbar or even in the All commands to bring it in.
Work around :
re install 2023 and in advance install Do Not check Workspace files . Now commands are visible in All Commands and you can re create your 2022 toolbars manually etc.
Enjoy !!
I have had situations where they disappear, but really there there.
Just not visible unless I close completely out of mc then start a fresh session and re open the file
There they are...sometimes with dimensioning too.
MOXA Antenna
on cnc plugged into rs232 port
Pc /.nc prog. To network through cimco dnc .
Wifi router on celing of shop Brodcasts code to cnc antenna
3d mold s
The auto toolpath regen function is a time saver ( I still note the file sz. Before the # crunch)
and the fact 2022 didn't screw me over in all the things / paths I use
Im impressed enough to pay maintenance for another go round.
The other programmer here picks the whole solid as well....
I lived through the " Dr. Watson" days where you had to pick each surface sometimes to see which one was crashing the system and had to be recreated so MC could crunch it lol
I have it.
I run my mill set. Set up sheet
Which gives me a tool list with the maximum Z depth for each tool.
I copy it and paste it into mc' "Notes"
Then I place it on the screen under the part and print the screen.
Done.
I can give you my mill.set post
And a quick video if your into it.
HSS Area clearence BLOWS the doors of surface rough pocket which i have used for a decade... it wastes it climb mills ALWAYS and doesn't drag the cutter across the floor going back to Geo etc. To finish it or clean it out...
Figure out the center distance
039 wide = .0197 etc
Now I do an offset curve from one of the edges.
Takes some quick trimming and a little clean up here and there.
* If you have text / Dims etc. You cant chain use Break ( lines ) ? and now you can.
You might have to much controller for your ball screws now.
We had Fadals with the Fanuc controller
It wore out ballscrews when the 88S ? Controller machines didnt
( they didnt get any serious work done either) lol
eMastercam - your online source for all things Mastercam.
Together, we are the strongest Mastercam community on the web with over 56,000 members, and our online store offers a wide selection of training materials for all applications and skill levels.