Hi All, We have a mold that we are machining which consists of 16 cores that stand proud.. While roughing the operator used a 6 dia endmill instead of the programmed 6 dia ballnose.. As a result its cut undersize especially on the shallower parts of the mold.. I've a stock model in my operations manager to reflect the correct 6 dia ballnose but is it possible to create another stock model to reflect the fact that the wrong tool was put in the spindle at the machine and not within mastercam, and then be able to compare the 2 models so that we have an idea of how much welding is needed? Thanks!

Hi, Is it possible to change the pinkish colour in of the stock model in verify? And also the yellow colour of the backplotted stock? Thanks

Hi, Whats the quickest and easiest way to remove holes or blank off holes in a solid that doesnt have a history? Thanks !

Hi all, what do most of you use in regards to toolpath verification? do you typically use the verify selected operations in operations manager and then compare to your original model ? Or are people using machine simulation to check with either backplot or verify? Im not finding much information on the latter but would like to learn more about it.. Any help would be appreciated! Thanks!

Thanks for the reply.. Turns out it was the rotary feed option in the control def.. I had it set to degrees/minute.. should be Unit/minute..

Hi All, Is there a way to stop the output of z0. feedrate eventhough my parameters say otherwise? Im only getting a few of these zero feedrated every now and again and im also getting some very slow feedrates sat 1.0 mm per min then it speeds up again.. Can i override the feedrate to a minimum? Using 2021 here.. Thanks

Hi , Is it possible to curve the engraving in the attached file so that it lasys in the red boundary area? Thanks

Hi, Just installed update 2 and am looking for the readme file to see whats been updated. Where would i find it? Thanks

Tried again today.. Uninstalled and removed folders ect.. Still crashes on startup.. Very annoying..

Josh, It was all running fine beforehand and yes it is a dedicated graphics card.. Will try your suggestions anyway.. Thanks!

Not an expert but this was one of the entries "Crash","4/09/2020","19:12:11","","McUex: Mastercam raised an Unhandled Exception","",15956

Has anyone has this issue? I think there was a windows update issue associated with this.. Anyway tried uninstalling and reinstalling but it just wont get past the spash screen before crashing every time..

Anyone else see this error in 2021? Cant remember exacly the message but something to the effect this process not available.. If i reset mastercam it seems to go away.. Only happened once so far..

Let's hope so.. Thanks

Ken I agree with your comments..clearly as far as I am finding with the fillet issue there was a problem with the initial release.. I'm not asking for extra features ect with an update just to fix a basic issue which is used dozens of times a day.. Life without this fix to me renders the software useless.. Especially sucks if you don't backup your files when it does crash.. How do I make a case for software fix for this given my maintenance has just expired?