The post is a generic haas mill post. I seem to remember having to edit the post when X first came out to not post the A0. for our VMCs without the fourth axis. I have'nt contacted our reseller yet was just courious if the was a simple fix. I got the post to output G55.

We have a new Haas HMC with a fourth axis how can I edit my post to output A0. in my G54 G90 line of the program? Also how do I get the post to output G55?

Were is the check surface stock to leave? I am running X6 MU1 and I dont see were to set my stock to leave on check surfaces.

Since installing X6 my auto cursor and general selection toolbars keep disappearing. The only way I can get them back is to minimize the screen if I maximize it one or the other will disappear again. I have downloaded MU1 and this still happens. Is there a fix for this? Does anyone else have this problem?

Does anyone else have the problem with toolbars disapearing?

Ok it does change color when I change planes.

Since downloading X6 I have been having problems with my auto cursor and general selection toolbars they will just disappear for no reason and I cant turn them back on. I downloaded MU1 this morning hoping this would fix the problem but it didnt. It actually caused another problem with my crosshairs the are color 11 I think they are actually the toolpath origin crosshairs. How can I turn them off?

I finally updated to X5 . Is there a way to migriate my machine and control defs from X4 ?

I did before I updated. It was good until I regenerated the program in MU1. It can eaisly be seen in backpolt. I should have looked closer at backpolt or used verify.

I am just updated to X3 MU1. I just wish mastercam would notify all users of major problems like this.

I had a major gouge problem while using surface rough pocket. I read through some old post and disabled the new arc filter. I hate updating mastercam everytime I get burned by something.

I am using a Nvidia Qoadro FX 1100 video card. I have noticed it will only crash when I press the S for step in backplot too soon.

Since downloading MR2 last week I have been having trouble with master cam crashing while trying to backplot. It dosent seem to matter if it is a large 3-D file or a simple 2-D toolpath. So far I have uninstalled all older versions of X and reloaded X2 MR2. I have not seen a differance . Has anyone else had this problem? Any suggestions would be greatly appericated.

I am not using parentheses in the manual entery dialog box. This is what I am getting the machine will read it with out a problem I just always get the code in parentheses also. M01 ( M01 ) S15000 M03 ( S15000 M03 )

Thanks for the help it works but, I get parentheses on one line and code with no parentheses no the next.