Search the Community
Showing results for tags '4axis'.
Found 3 results
I have created a program that finishes with a 4-axis rotary tool path. I am using a Haas VF2 with the Generic 4-axis haas post from MasterCam. It's about 80K lines of code that get output using G93 Inverse time feed. Feed is non-modal when using G93 so there needs to be an F-value on every single line while G93 is active. About 1 out of every 20 lines does not have an F value and I can't figure out why.. any thoughts as to how I can fix this? Thanks, Al
Hello everyone, I'm having trouble configuring the generic fanus 5 axis post. I have a c/b head setup but when I tell the B axis to rotate 90 degrees during a TPlane change, it tilts up much further than 90 degrees. Is there a way to calibrate the postprocessor so that the B axis is in the correct angle? Values for rotary limits seem to only accept units such as millimeters, however 90mm does not correspond to 90 degrees on my machine. Thanks, John.
Hi Guys Anyone in here with programming experience on Fanuc Robodrill with 4th axis? It's an 31i B5 control. I'm new to programming on Fanuc and i'm trying to get the MasterCam Post Processor working. I've made a simple program with tilted "B" axis in 57degrees. (I know i should be "A" but apperently thats the way Fanuc makes it!) If I delete G53.1 it works, but isn't it necessary? Also if you see any other problems in my program please let me know Regards Jacob test.txt