Search the Community
Showing results for tags 'dynamic mill'.
Found 5 results
-
Hello all, I would like to thank you in advance for your help and efforts.
-
Hello and Good Morning! I have a plate looking like a pie (removing that pie form the whole circular billet). After facing, I am using 2D Dynamic mill to cut the edge. Parameters seems to be correct, however, the toolpath is not generating. It says invalid NCI. any help here, what could be the problem? Thank you in advance!
-
Have any of you run into this issue? I can't show this model, but essentially what is happening is that as this material gets thinner, the step over increases when it whips around 180 degrees. When done, there is no fin left, this is a recessed area. I'm using a 1/2" endmill in hardened stainless 4% radial engagement. It does not like the heavy stepover. For what it's worth, I'm using 2021. Any tricks or 2022, 2023 have a fix?
-
I'm looking to shave some time off a production job and have been given the green light to research new tooling to do so. One of the biggest questions I've always had was how much does the helix angle on the cutter affect the tools performance when using a dynamic tool path? What angle would give you the all around best performance 30, 35, 40, or 45° ? Any insights on the subject would be greatly appreciated. BTW - These parts are aluminum and will be running on 2 different machines. one with 20000 RPM (okk) and another with 12000 RPM (Hurco)
-
Why
