Search the Community
Showing results for tags 'tailstock'.
Found 3 results
-
Hello everyone, I was creating a simple lathe toolpath (finish a line) and when I went to prepare my stock setup, into Machine Group Properties, I couldn't see all parameters to fill, it means, I can't see all the window, as the picture below. I have already tried, for hours, change my screen resolution but didn't work. And the fonts are also BOLD, does anybody know how to fix it? Will help me a lot. PS.: I'm using Mastercam 2019 (I tried using Up1, Up2, and Up3). The error does not appear in Mastercam 2020 (Any TP or Beta) Thanks Kenny Machado
-
is there someone that could give me the steps from the beginning on how to define my tail stock so i can see it while i am programming? i have been running lathe for years now and have never had to use it but i have a job where i need to see it while i am programming and i cant for the life of me find anywhere that tells me how to set it up in the machine or control definition. Thanks in advance
-
Just a quick question on how far out do you normally stick your stock out of the chuck when you decide to use a tailstock? This is just a general question for general turning, I know the answer would change if I wanted to make a tooth pick out of 1" stock... I was tginking it would be about 5:1 ratio?
