Hi everyone, first time poster here.
I obtained a post processor, but it is for mastercam 2020, and we currently have mastercam 2018 with no means to update as of now.
Is there any way to change the post to allow it to run on mastercam 2018 version?
Thank you
I'm not sure the OP is legitimate...
That said, I'm not sure keeping this a "secret" is really necessary, since there are some structural issues which make a "clean break" between the Mastercam X Series, and the 20xx series of the software.
To roll-back the Post Processor, you need to edit the 'Post Version' line at the top.
This line has variables which tell MP.DLL information about the construction of the Post itself.
You'll see several different Alpha Addresses, with the s