Thread diameter value into a comment in the outputted nc code
Hi!
I have a question if it is possible to capture the major thread diameter value into a comment from the post processor.
or if it is available as a value in a tag for setup sheets?
see attached image
Now i just put the value in the comment field, but sometimes that is also used for other comments so it gets a little crowded.
I do thread milling on daily basis and have an access database of my default values and compare that to the program output and if it
is and o
My solution to this was as follows:
in this section i added this:
# --------------------------------------------------------------------------
# Toolchange / NC output Variable Formats
# --------------------------------------------------------------------------
fmt 2 Threaddiameter #Threadmill diameter value
fmt 2 Threadpitch #Threadpitch value
fmt 4 Threaddirection #Thread direction - bottom = 0 or top =1
fmt 4 Threadteeth
