need help create this part on the rotary axis

[angela111]

hello,

 

I am trying to machine this part but I am having trouble. The tool is cutting way too much material because the depth of cut is not set properly. How do I set the depth of cuts?

 

Thank you

5FINAL.MCX-7

[betts]

The short answer is under the "Roughing" page/tab, but I wasn't sure what you were having trouble with. The stock geometry doesn't show that much material. If the cylinder is your actual stock then I can see where you will need depth cuts.

 

HTH

[angela111]

The short answer is under the "Roughing" page/tab, but I wasn't sure what you were having trouble with. The stock geometry doesn't show that much material. If the cylinder is your actual stock then I can see where you will need depth cuts.

 

HTH

 

thank you for your respond. yes,The stock geometry should be a cylinder. When I go to roughing page/tab and click on the absolute options . what values do I put for maxium depth and mininum depth?