-
Posts
5 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Posts posted by Skip Baker
-
-
How can I strip the Mplfan.pst (default Lathe post) back to a simple 2 axis (X,Z only) post. I'm trying to post to a Tormach PathPilot lathe. I've reworked many mill posts but this is the first time working on a Lathe post.
Mastercam 2022
-
I'm getting better using the debugger. It's much nicer than the old one in Mastercam X. I'm currently running X7 and using the mpmaster.pst. My last job at work was the IT focal for the Mastercam users. I did a number of custom posts including a custom drill cycle for a Fadal deburing holes on assemblies. It's jut been over 5 years since I've worked on posts. I can had write taping cycles until I can get it to output the exact code. Not sure if the dwell will ever change. That's a good question. I could see it may need to change if the spindle speed changes too much.
It was allot easier to do right after I took the posts training at CNC. But that was 7-8 years ago when Mastercam V9 went to X.
-
I tried that already. It was close but not close enough. Had problems with the tool starting at the bottom of the hole. Then I had problems with the timing partially due to the dwell being before the spindle stop. Getting close but still not there yet. I'll get it eventually. It's pausing too long when the spindle reverses. The sample code from Tormach works great. I'm just hand coding tap routines for now using a manual operation.
-
It's been 4-5 years since I've worked on Mastercam Post files. I need to create or just replace the ptap$ section of code in the mpmaster.pst to create this output for a custom tap routine. I could really use some help getting back into this or help developing this cycle.
This is an example of good manual code that runs properly.
(Tap: 1/4 20)
N10 G90 G80 G40 G54 G20 G17 G50 G94 G64 (Safety block)
N20 M03 S400 (Spindle on CW)
N30 G0 X2 Y2 Z.1 (Rapid to Above 1st Hole)
N40 G1 Z-.5 F20 (Begin Tapping 1st Hole)
N50 M04 S400 (Reverse Spindle Direction)
N60 G4 P.5 (Dwell, 0.5 Second)
N70 Z.1 F20 (Retract)
N80 M03 S400 (spindle on CW)
N90 G4 P.5 (Dwell, 0.5 Second)
N100 G0 X3 Y2 (Rapid to Above 2nd Hole)
N110 G1 Z-.5 F20 (Begin Tapping 2nd Hole)
N120 M04 S400 (Reverse Spindle Direction)
N130 G4 P.5 (Dwell, 0.5 Second)
N140 Z.1 F20 (Retract)
N150 M30 (Program End)I have the Volume 3 PDF files for Mastercam Version 9.1 Post Processor as a reference. I could use Volume 1 & 2. Is there somewhere I can download these first 2 volumes?
Any help would be greatly appreciated!
Need help striping lathe post to 2 axis only.
in Post Processor Development Forum
Posted