20 hours ago, content creator said:

For single surfaces, surface finish flowline usually does it.

Ive tried the flowline with no success either, also adjusted my z levels when trying to use the finish parallel toolpath. Not sure if I have bad data or if it's just my lack of exp. I uploaded a picture of how the flowline is looking for me, also attached a file. 

IV BLOCK FL.mcx-9

Will do, still new to the 3D Toolpaths. Trying my best to teach myself and make it happen the best I can.

thank you!

Unsure of where I am wrong here, I cant get the toolpath to follow the boundary,the radius is .0787, I selected a .125 ballnose, now it is acting as if the cutter is too big.

New to 3D toolpaths so 

any help is appreciated!

Mastercam file attached

Thank You

BLOCK.mcx-9

Not really sure what to ask but Is there a way to rotate the model to the 32.5 degrees?  I have to mill a slot on a 32.5 degree angle, and need to orientate the model before choosing a new WCS,  when I go to rotate it only wants to rotate off the X axis..  using a 3 axis haas mill running mastercam x9. Still fairly green to programming and have been teaching myself off videos< and the forum. thanks   

WELP NEVER MIND. IM A DUMMY. I FIGURED IT OUT. THANK YOU.