Mastercam 2023 Setting Origin of Stock

[Hoopester]

Getting used to 2023 version, and I'm struggling with moving the location of the origin of my stock model.  It seems simple enough, click the radio button where you want the origin located (default is center of mass for the rectangular shape).  I want to change the location of the origin to the top surface, remain in middle.  I hit the radio button then the green check mark, close the dialogue box, and nothing changes.  I open up the stock model settings, and the origin is still stuck in the middle of the part.  It doesn't change.  VERY annoying.  Suggestions?

Pin Holder Fixture.emcam