mpsubrep.pst

[stan z]

Hello my forum buddies,THE POLISHMAN IS HERE.I have searched the forum on this topic and have some questions.The output when using this post is what I am looking for but, how is that you utilize it for my posts.I have two posts I would want to use the sub programming(meldas control and a mori seiki). I had these tweaked in with my reseller but would like to work on these posts myself .Would it be best modify my posts (save a back up OBVIOUSLY)and figure out where to edit them to have the posts output the right code WCS,Pxxx ,ETC. and if so how difficult would it be .I believe I would want the post seperate for sub programming only, as these applications would only be used on my vertical machines.

[CAM Disciple]

Do you have the post reference guide cd?

 

It should not be that difficult.

 

Ask question if you have problem and somebody will help you.

[stan z]

I do not have the C.D. ref. Would that be on my m-cam install C.D. or is that a purchased item?

That is exactly why I am asking how to do it ,if the guide is what would help then i will proceed with that.

[Steve Biehl - Cimquest Inc]

Stan,

you get the CD from your dealer.