M19 and reset

[heeler]

Would someone here know what parameter to change on a fanuc 21i control so that if you use an M19 spindle orient command, it will stay active when you push reset, or M00/M01. We are using the renishaw ball bar system, and are having problems with one machine. After we capture the ball and send the cup to the position to load the bar it lets the spindle turn a little bit. When we then push cycle start it will reorient which causes some problems. Our Daewoo's with an 18M control does not release the spindle on the M00/M01. So I would think that this is a parameter setting.

 

Thanks

 

Glenn

[Leandro]

Glenn

In our Acramatic control we had to define this "tool" (the Renishaw probe) as a probe and automatically is all done.

No turning, 50% feed and so on.

May be you had to define as "probe" your tool.