lathe problem

[fantasma]

I have a problem any time i create a part on lathe mode and save it and next time I open to modify that part open with the mill icon , then I open the set up manager and also appear the mill mode set up.

 

please help

 

when i save the part that seems goes to the right folder(lathe mc9)

[Guest]

setting >> configuration >> start/exit >> make sure default machine is unchecked.

 

I believe this will default the file to the last setting it had.

 

 

Also, if you go into page 11 in your MasterCam X Installation guide in your documentation folder,in the chapter Preparing for your MasterCam X installation, there is a section that talks about command line switches. If the above does not work you might want to check that section out.

 

HTH

 

[ 10-29-2005, 03:13 PM: Message edited by: jmparis ]