Post Question

[SBA]

I am trying to find a problem with "N" sequence number output. Lathe post canned rough cycle. There is a seqinc$ that may be the problem. Were do the values of seqinc come from? In the rough canned cycle, the call line is always increased by 250 form line before.

[Guest]

What is the problem?

 

A lathe canned cycle is best to have its own sequence N #'s Best way I know to avoid possibly having to N #'s the same.

[SBA]

I am getting this on output

N10 G0 X50. Z50.

N20 G50 S1600

N30 T0100

N40 G0 G97 S50 M03 M42

N50 G0 Z3.145 T0101

N60 G0 X2.0008 M8

N70 G50 S1600

N80 G96 S275

N330 G85 N340 U0. W0. D.4 F.01

N340 G81

The problem I am trying to fix is the N330 line. This post was converted from v9. In V9 the N330 line would be N90. If I have another rough cycle it does the same thing. It always changes by 250. I can renumber it after post or it will run as is but I would like to fix it.

Thanks

[Guest]

SBA,

 

Check of this thread there is a suggestion about fixing a problem similiar to yours about halfway down.

 

Linky

 

 

HTH