G92 in wire program

[flippinjig]

Ok, here goes. I've got a Charmilles wire with a fanuc control. It's got an automatic wire threader that really works well so I like to program several parts out of the same piece of steel. If the wire breaks it will go back to the last G92 it read, rethread and retrace back to the break point and start up again. I would like to post a G92 after every G0 line and before the M60. Example:

 

G0 X1. Y1.

G92

M60

 

I'm using ver 8.1 with MPWFANUC.PST.

 

Seems simple but I just can't figure it out.Any thoughts?

 

Thanks, Mark

[Guest]

i had the same problem with my fanuc post, when

i tried to "window contour" multiple part geometry. i contacted my mastercam dealer and sent

him a copy of my post.after a couple of tries

he got it right.i am sure your dealer can do the same.

[flippinjig]

Del,

Welcome to the forum.What version are you using?

[Guest]

thanks,

i am currently using wire 9.1.

i have mastercam x design and am trying to get

used to all of the changes.as far as i know wire x

is not out yet.

[flippinjig]

I'm using 8.1. It works ok for me, I just want to iron out some stuff so I don't have to do so much editting to the .nc file.