mill and wire toolpaths

[mnJeffs]

here is a glitch I am getting. I have programed a block for mill and add my next machine group and do my wire paths. When I see I need to add another toll to the mill paths. I add it and get this error when i got to post.

 

Cannot read from nci file

id#6 contour 2-d

 

if I go and delte wire paths and machine group and add extra mill tool path to the first mill machine group. it works just fine. then i have to redo wire from scratch.

[Steve Biehl - Cimquest Inc]

works fine here. I created a mill contour, then a wire contour and then went back to do another mill contour. No problem. Did you move the red arrow back to the mill group?

[Roger Martin from CNC Software]

mnJeffs,

 

FYI,

There is an issue that has been logged on this and is being investgated.

 

Thanks for you input!

[mnJeffs]

that is all I was doing was getting it logged. and yes put red arrow back into mill area. there is other minor problems with both in same file but I will work around them till The next update.