Remove m62 and m63

[Butch103]

How to remove G62 and G63 from in the middle of skims

 

% N010 M63

N020 D01 P00 S01 T01 G43

N030 G01 X+000000 Y+009525 G44

N040 G01 X+003175 Y+000000 G40

N050 G03 X-006350 Y+000000 I-003175 J+000000 G44

N060 G01 X+000000 Y-019050

N070 G03 X+006350 Y+000000 I+003175 J+000000

N080 G01 X+000000 Y+008255

N090 M00

N100 G01 X+000000 Y+001270 G44

N110 G01 Y+001000

N120 G01 X-000381 Y+000000 G40

N130 G45

N140 M62 -------------------Remove

N150 G01 X-002684 Y+000000 G40 M22

N160 G01 X+002684 Y+000000 M22

:170 M63 -------------------Remove

N170 D02 P00 S02 T02 G43

N180 G01 X+000000 Y+009525 G44

N190 G01 X+000381 Y+000000 G40

N200 G03 X-006350 Y+000000 I-003175 J+000000 G44

N210 G01 X+000000 Y-019050

N220 G03 X+006350 Y+000000 I+003175 J+000000

N230 G01 X+000000 Y+009525 G44

N240 G01 Y+001000

N250 G01 X-000381 Y+000000 G40

N260 G45

N270 M62 ------------------Remove

N280 G01 X-002794 Y+000000 G40 M22

:290 M63 -------------------Remove

N290 D03 P00 S03 T03 G43

 

 

Mastercam X2 MR1 SP1

Agie Generic AC123 4X wire.pst

 

Butch

[Guest]

you might try post debugging in your control def under nc output.enable post debugging and find where that is at in your post and put # in front of that post line.

[Ashan]

If you do not need M62 M63 at all

Then block the line which have M62 M63 by # and see what happens

It may help you

[Roger Martin from CNC Software]

Butch103,

 

Questions...

You never want the M62/M63 codes to output?

If this is the case you should be able to eliminate these codes from being output by doing this...

* Make a backup of your PST first! *

 

Original section in PST ->

code:

---

# M-code selector

sm00 M62 #Cut wire, for M non-modal

sm01 #Upgrade to 0, cut wire

sm02 M21 #Wire and no power

sm03 M63 #Thread wire

sm04 M22 #No wire with motion

smcode #Target for string

---

Altered section in PST ->

code:

---

# M-code selector

sm00 M62 #Cut wire, for M non-modal

sm01 #Upgrade to 0, cut wire

sm02 M21 #Wire and no power

sm03 #Thread wire

sm04 #No wire with motion

smcode #Target for string

---

or

 

Are you getting these codes when you think there not needed ('between skims'),but they are needed at other times?

If this is the case, send me an email, by clicking on the email icon at the top of this posting. I'll shoot you back an address where you can send me Z2G package and I can have someone look into this for you.