M29 not posting

[mxdan]

M29 is not showing in my post for a ridid tap cycle? I have the rigid tap cycle checked in the drop down list, it used to work before, I may have turned something off by mistake? I'm sure

its so simple I have just over looked it. X2 MR2 SP1 w/CIMCO Edit V5

[chris m]

I don't know about X posts, but I just hardcoded the M29 in the post I have that needs it:

 

ptap #Canned Tap Cycle

pdrlcommonb

result = newfs(12, feed) # Set for tapping Feedrate format

pbld, n, "M29", e #(cdm)

pcan1, pbld, n, *sgdrlref, *sgdrill, pxout, pyout, pfzout, pcout,

prdrlout, *feed, strcantext, e

pcom_movea

[mxdan]

found it (RESTORE CATAGORY) for rigid taping in

the control definition settings, I don't know how that got turned off? but then again I don't know how a lot of things happen??? TOO MANY DOG COLLARS!

[Guest]

quote:

---

it used to work before

---

OK, before what?

 

Just previously or have you recently updated your post?

 

The M29 is "generally" hard coded to output when the condition checks all say it should, so if nothing is changed in the post, something has changed in the way you choose your cycle.

 

If you go back to the drop down menu where you choose your cycle is there another tap choice?

[mxdan]

I think it may have happend when we went from MR1 to MR2, could that be possible?