geometry selection gremlins

[wildcat99]

For some reason, all of the sudden when selecting entities, they don't highlight until after I rotate the part slightly. Any ideas?

 

Also, in an existing toolpath, when clicking on the chain name in the chain manager, it doesn't highlight the chain on the screen.

 

And when clicking on a toolpath in the op manager, it doesn't highlight geometry on the screen like it used to.

 

X2 MR2 SP1 with a Quadro FX3450 card and nothing's changed as far as I know. So far I've tried restart, lowering the hardware acceleration, and updating the driver with no luck.

 

Anyone else seen this?

[wildcat99]

Auto highlight is what I've lost. A simple function you take for granted until it's gone.

 

I tried turning the Unified back/depth buffer back on, off, on and off again with restarts in between....nothing.

 

It still works for surfaces, but not lines, arcs, splines. How do I get it back? I appreciate any suggestions. Thanks

[Justin Beebe at Folsom Tool]

wildcat99

 

1. Setttings

2. Configure

3. Screen

4. Check box for auto highlight then save

[wildcat99]

Problem solved!

 

A couple days ago I installed Autodesk Design Review 09 and DWF Writer. I just un-installed both and now all is well. I guess they don't play well with Mastercam?

 

Thanks Justin, that was the weird part cause I've had auto highlight checked the whole time.