post wire 7

[mario]

when me post 4 axes none problem but that me post 2 axes the post make me the double program without I ask him and my

NUMBER OF SKIMCUTS BEFORE TAB = 1

thank you!

P.S. I apologize of the raffale of my question this morning I am inspired

hihihi!!!

thank you again

I adore this way to make and I read all the headache of everybody and that helps me thank you!

[This message has been edited by billy (edited 11-10-2000).]

[Christian Raebild]

I do not understand the sentence "I apologize of the raffale of my question this morning I am inspired". It is the word "raffale" which confuse me.

As for your "double program" problem, that seems to be a post processor problem. I have not seen that problem before, and I have worked with a lot of wire post processors, so you should contact your local Mastercam dealer.

Christian, post processor developer for CIMCO Integration, the Danish Mastercam reseller.

[Guest]

Do you use a pre Version 7 Wirepost in Version 7 without using the chook "uptxt7" ?

This caused the same behavior at one of my clients some month ago.

Robert